< Back
Print

Station configuration

Adding stations

Now you can add a station to the SAWSConnector module. In order to do so, navigate to the SAWSConnector module and click on the “Add new station” button:

neue-station

In the pop-up window, enter all necessary information and click on “OK” when you are done.

station1

station2

You will be taken to the overview page of the station; it should look something like this:

queldatenset0
If you chose to ass a new source data set when you added the station, click on the “Edit source data set” button (see red mark above). You will be taken to the edit mode of the source data set and need to configure it first.

Was this article helpful?
How can we improve this article?
Please submit the reason for your vote so that we can improve the article.
Previous Intellishop Installation
Next Source data set configuration
Table of Contents